MasterForce 241-0300, Руководство оператора, Страница: 8 / 24

8
Do not operate the tool at full-load for more than 30 seconds, as this can
cause the motor to become too hot, which may damage the motor.
Release the trigger immediately when the screws are tightened to avoid
breaking the screw.
For best results, your battery tool should be charged in a location where
the temperature is more that 50°F (10°C) but less that 104°F (40°C). Do not
store outside or in vehicles.
SAFETY RULES FOR CHARGER
WARNING!
Read and understand all instructions. Failure to follow all in-
structions listed below may result in electric shock, fire, and/or serious per-
sonal injury.
Before using the battery charger, read all instructions and cautionary markings
in this manual and on the battery charger, the battery, and the product using the
battery to prevent misuse of the products and possible injury or damage.
CAUTION!
To reduce the risk of electric shock or damage to the charger
and battery, charge only these rechargeable batteries specifically designated
on your charger’s label. Other types of batteries may burst, causing personal
injury or damage.
Do not use the charger outdoors or expose it to wet or damp conditions.
Water entering the charger will increase the risk of electric shock.
Use of an attachment not recommended or sold by the battery-charger
manufacturer may result in a risk of fire, electric shock or injury to persons.
Do not abuse the cord or charger. Never use the cord to carry the charger.
Do not pull the charger cord to disconnect the plug from receptacle.
Damage to the cord or charger could occur and create an electric shock
hazard. Replace damaged cords immediately.
Make sure that the cord is located so that it will not be stepped on, tripped
over, come in contact with sharp edges or moving parts, or otherwise
subjected to damage or stress. This will reduce the risk of accidental falls,
which could cause injury and damage to the cord, which could then result
in electric shock.
Keep the cord and charger from heat to prevent damage to the housing or
internal parts.
Do not allow gasoline, oils, petroleum-based products, etc. to come in
contact with plastic parts. These materials contain chemicals that can
damage, weaken, or destroy plastic.
An extension cord should not be used unless absolutely necessary. Use of
an improper extension cord could result in a risk of fire and electric shock.
If an extension cord must be used, make sure that:
The pins on plug of extension cord are the same number, size and shape