D
RY
& W
ET
O
PERATION
The IT-Vacs are equipped with by-pass
motors, designed for dry or wet pickup.
They are shipped assembled with the
hose, wand and tools packed in the ship-
ping carton.
Dry Operation
This vacuum is shipped with the dry filter
in place and is set up for dry pickup.
Dry Setup
After Wet
Pickup
1.
Remove the motor head and set
aside.
2.
Lift up on the front handle and tilt
tank back and empty contents into a
suitable drain.
3.
Set dry filter assembly on tank,
replace motor head and snap down
clamps.
Setup
for Wet Operation
When using this vacuum for wet pickup
the dry filter must be removed. The float
cage is attached to the bottom of motor
head and remains in place for dry and
wet operation.
1.
Disengage holdown clamps remove
motor head and set aside.
2.
Remove dry filter, set aside.
3.
Replace the motor head, and snap
down clamps.
Always exercise CAUTION when handling the motor head.
Dropping the motor head may cause damage to the internal components.
C
AUTION
:
P
AGE
4
1. Hose to Inlet:
Push the red button on the inlet to the
left and insert hose. Release button and
the hose is connected.
2. Wand Assembly
Push straight ends of wands together.
3. Hose to Wand:
Slide the free end of hose onto one end
of the wand.
4. Wand to Tool:
Select the required tool for vacuuming
and attach it to the free end of wand.
V
ACUUM
M
AINTENANCE
Dry Filter
In order to maintain maximum efficiency
of this vacuum cleaner it is important to
clean the cloth filter each time the tank is
emptied.
To clean the cloth filter, shake off loose
particles and brush exposed surface
with a soft bristle brush.
Wet Pickup
DO NOT
store this vacuum with any liq-
uids inside the vacuum. Before storing
or converting over for dry pickup run
emptied vacuum for approximately five
minutes to eliminate moisture in the
tank, hose and attachments
Empty liquids from Tank
1.
Remove the motor head and dry filter
.Set aside.
2.
Lift up on the front handle and tilt the
tank back to empty the contents.
Note:
The tank can also be removed
from the dolly by rotating the quick
release system.
H
OSE
, W
AND
& T
OOLS
I
NSTALLATION