Installation
3
For parts or assistance, call customer service at
1-877-455-5508
Use 1/2" hose (or larger)
Use a reinforced hose on the inlet. The
pump should be less than 10’ above and
less than 25’ to one side of the water
source. Make the outlet hose as short as
possible – 25’ or less.
Check the washer in the inlet fitting to
make sure it is airtight. If this joint leaks
air, the pump will not operate.
KEEP THE HOSES AS STRAIGHT
AS POSSIBLE
To reduce friction, do not coil or kink the
hoses. When pumping from a well or
stream, raise the inlet hose a few inches off
the bottom to avoid sucking in sand, silt or
pebbles (which can disable the impeller).
Install a strainer or the Pud-L-Scoop
TM
to
protect the pump from large solids.
NOTICE:
Attach the Pud-L-Scoop
TM
to the
end of the inlet line and place it in at least
1/2" of water at the lowest point to be
pumped. Be sure all connections are air tight.
INLET HOSE GOES IN THE
WATER; OUTLET HOSE STAYS
OUT OF THE WATER. MOTOR
MUST STAY DRY
Make sure all inlet connections are tight
(no air leaks) and the inlet hose is in the
water. Make sure the end of the outlet hose
is
not
under water. If the outlet is under
water, the pump may not work.
Plug the cord into a 3-wire, 115 volt,
60 Hz, grounded A.C. outlet.
You should get water in 30 seconds or less.
If not, add more oil and repeat the process.
If your pump does not prime on the sec-
ond try, check the impeller and the inside
of the pump head for wear. Replace as
needed.
In rare cases you may need to prime the
pump. To prime it, fill the suction hose
with water, put it back in the water source,
and start the pump.
The motor must have air circulation
around it for proper cooling. This pump
will lift water 10’; trying to lift water more
than 10’ can cause the motor to run hot.
The motor has a thermal overload which
will stop it if it gets too hot. If the motor
stops, allow it to cool for 30 minutes
before trying to start it again.
IN
OUT
1/2" or Larger
Outlet Hose
4837A 0205
Water OUT
Water I
N
1/2" or Larger
Reinforced
Inlet Hose
2
No kinks!
No Coils!
Straight
Hose!
3
IN
Water I
N
Water OUT
Outlet Hose
Plug in pump to start it.
NOTE:
If you don’t get water in
30 seconds or less, add more oil
and repeat the process.
See Step 1.
Inlet Hose
4