For parts or assistance, call customer service at
1-877-455-5508
Safety
2
SAFETY INFORMATION
Use this pump only on a 115
volt circuit. Pump is equipped
with an approved 3-conduc-
tor cord and 3-prong, grounding-type
plug. To reduce the risk of electric shock,
connect it to a properly grounded,
grounding-type receptacle.
If circuit has a 2-prong receptacle, replace
it with a properly grounded 3-prong recep-
tacle installed in accordance with the
National Electrical Code and local codes
and ordinances.
Any extension cord used must be outdoor
grade, gauge 16 AWG or heavier, and not
more than 25’ long.
Risk of fire or explosion if
used to pump flammable liquids or if used
in explosive atmospheres.
Pump water
only with this pump. Pump is designed
to pump water at temperatures between
32°-77° F (0°-25° C) only.
Risk of electrical shock. Do
not allow the motor to get wet!
Risk of burns.
During nor-
mal operation, motor case may heat
enough to burn you. Do not touch motor
when it is hot.
Do not operate the pump continuously at a
discharge pressure of more than 12 psi
(83 kPa) or discharge lift of more than
28’ (8.5 M), as the motor will exceed the
normal safe operating temperature and
may heat to 180° - 190° F (82° C - 88° C).
Pump water only with this pump.
NOTICE:
This unit is not designed as a water-
fall or fountain pump, or for applications
involving salt water or brine! Use with water-
falls, fountains, salt water or brine will void
warranty.
Do not use where water recirculates.
Not designed for use as a swimming pool
drainer.
INSTALLATION
Oil the pump
Oil the pump with 1/2 tablespoon food
grade mineral or vegetable oil with each
use. Pour the oil in the ‘IN’ port. Three 1/2
tablespoon oil packets are included.
NOTICE:
The pump depends on the liquid
being pumped for lubrication.
DO NOT RUN THE PUMP DRY!
If the pump does not start to move water in
30 seconds or less, recheck the installation
and plumbing.
Mount the pump solidly on a stable
platform.
Hazardous
voltage
IN
IN
Oil
Do Not Run Pump Dry!
1