MasterCraft 058-9847-6, Руководство по эксплуатации

Страница: 9 / 15

17 16
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
model no. 058-9809-8 | contact us 1-800-689-9928
model no. 058-9847-6 | contact us 1-800-689-9928
Testing the nailer
(1) DISCONNECT AIR HOSE FROM NAILER.
REMOVE ALL NAILS FROM NAILER.
●
All screws must be tightened. If any
screws are loose, tighten them
(Fig. F).
●
The push lever and trigger must move
smoothly
(Fig. G).
(2) Adjust the air pressure to 70 PSI (4.9 bar
or 5 kgf/cm
2
). Connect the air hose.
●
THE NAILER MUST NOT LEAK AIR.
(3) With finger off the trigger, depress the
push lever against the workpiece
(Fig. I).
●
THE NAILER MUST NOT OPERATE.
(4) Separate the push lever from the wood.
Point the nailer downward, pull the trigger
and then wait in the position for 5 seconds or longer.
Then depress the push lever against the wood
(Fig. L).
●
THE NAILER MUST OPERATE
(6) Remove all nails from nailer.
Do not push or rest push lever against any surface or switching device will not turn.
Do not force or use any tools to turn switching device.
Move switching device completely to the leftward position (contact actuation mechanism).
(7) With the nailer off the workpiece, pull the trigger.
Next, depress the push lever against the workpiece.
Now pull the trigger.
●
THE NAILER MUST OPERATE.
(8) If no abnormal operation is observed, you may load nails in the nailer.
Drive nails into a test piece that is the same type of material that will be used in the actual application.
●
THE NAILER MUST OPERATE PROPERLY.
Fig. F
Fig. L
Fig. G
Before actually beginning the nailing work, test the nailer by using the check list below. Conduct the
tests in the following order. If abnormal operation occurs, stop using the nailer and contact a service
centre immediately.
WARNING!
●
Never use nailer unless push lever is operating properly.
Always wear eye protection.
Push lever
Trigger
Do not connect
air hose
Fig. I
Fig. H
Do not pull trigger
Depress
push lever
Pull trigger
Rightward position
Switching device
(5) Without touching the trigger, depress the push
lever against the workpiece. Next pull the trigger
(Fig. M).
Fig. M
Leftward position
Switching device
Hole
Remove all nails from nailer.
Do not push or rest push lever
against any surface or switching device
will not turn. Do not force or use tools to
turn switching device.
Move switching device completely to
the rightward position (single sequential
actuation mechanism)
(Fig. H).