15
model no. 058-9338 | contact us 1-800-689-9928
14
Note
:
Before loading nails in the magazine, adjust the plate. If the magazine cover
is forcibly closed without adjusting the plate correctly, the nail holder may
be damaged.
Be careful not to deform the collated wires and not to disengage the nails
with the guide surface. Otherwise, the nail guide will not close correctly.
DANGER!
Loading nails
Potential hazard that will result in serious injury or death.
DANGER!
Never place your hands or feet closer than 8” (20 cm) from firing
head when using.
Do not drive nails on top of other nails or with nailer at too steep
an angle. Nails can ricochet and hurt someone.
In order to avoid double fire or unwanted ejection of a nail due to
bouncing of the nailer, do not push nailer on workpiece using
recoil, take nailer away from workpiece with strong force, or
release trigger quickly when performing trigger fire.
Do not drive nails from both sides of a wall at the same time.
Nails can be driven into and through the wall and hit a person on
the opposite side.
Never drive nails into thin boards or near corners and edges of
workpiece. Nails can be driven through or away from workpiece
and hit someone.
Never use nailer which is defective or operating abnormally.
Never use nailer as hammer.
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
1. Disconnect the tool (1) from the air
supply (2). Grip the nail guide and knob
with finger, press the knob down and
swing the nail guide open to open the
magazine cover (Fig. A).
2. Adjust the position of the plate to accomodate the
nail length. The nail will not feed smoothly if the
plate is not correctly adjusted.
Turn the nail holder about 90 degrees
counter-clockwise.
The nail holder slides vertically up or down. Lift or
lower the nail holder to hold different length nails.
Adjust the plate to the nail length reference
points on the magazine cover and turn the nail
holder 90 degrees clockwise until you hear “click”.
4.
①
Uncoil enough nails to reach the driving hole.
②
Insert the first nail into the driving hole and the second
nail between the two pawls of the feeder.
③
Fit the nail heads in the guide slot.
④
Pulling the nails to the right, swing the nail guide closed.
⑤
Close the magazine cover first, and then swing the nail
guide closed.
⑥
Lock the knob correctly (Fig. D).
Fig. A
Fig. B
model no. 058-9847-6 | contact us 1-800-689-9928
Disconnect the tool from the compressed air source before
loading nails.
Do not point the tool towards the operator or other people
while changing nails.
Do not hold the tool with the trigger pressed while changing nails.
Failure to comply will lead to serious injury or death.
When loading nails into nailer: do not pull trigger, do not depress
push lever, and keep nailer pointed downward.
Potential hazard that will result in serious injury or death.
Knob
Nail guide
Magazine cover
3. Place the nail coil into the magazine.
Uncoil enough nails to reach the
driving hole (Fig. C).
Fig. C
Fig. D
Magazine
Nail holder
Nails
Nail guide
First nail
3
1
2
4
2
Feeder
Guide surface
Driving hole
Guide slot
Nail holder
Magazine
3
1
2
2"
2
1
/
4
" 2
3
/
8
"
2
1
/
2
" 2
3
/
4
"
3" 3
1
/
4
"
①
②
③
