15
model no. 058-9338 | contact us 1-800-689-9928
14
Note
:
Before loading nails in the magazine, adjust the nail holder. If the magazine
cover is forcibly closed without adjusting the nail holder correctly, the nail
holder may be damaged.
Do not deform the collated wires and do not disengage the nails with the
guide surface. Otherwise, the nail guide will not close correctly.
Potential hazard that will result in serious injury or death.
DANGER!
Loading nails
Disconnect the tool from the compressed air source before
loading nails.
Do not point the tool towards the operator or other people while
changing nails.
Do not hold the tool with the trigger pressed while changing
nails. Failure to comply will lead to serious injury or
death
.
Potential hazard that will result in serious injury or death.
DANGER!
Never place your hands or feet closer than 8" (20 cm) from firing
head when using.
Do not drive nails on top of other nails or with nailer at too steep
an angle. Nails can ricochet and hurt someone.
In order to avoid double fire or unwanted ejection of a nail due to
bouncing of the nailer, do not push nailer on workpiece using
strong force, take nailer away from workpiece using recoil,
release trigger quickly when performing trigger fire.
Do not drive nails from both sides of a wall at the same time.
Nails can be driven into and through the wall and hit a person on
the opposite side.
Never drive nails into thin boards or near corners and edges of
workpiece. Nails can be driven through or away from workpiece
and hit someone.
Never use nailer which is defective or operating abnormally.
Never use nailer as hammer.
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
1. Disconnect the tool (1) from the air
supply (2) (Fig. A).
Knob
Nail guide
Magazine cover
Magazine Nail holder
Plate
For 7/8, 1 and
1 1/4"
(22, 25, 32 mm)
For 1 1/2" (38 mm)
For 1 3/4" (45 mm)
3. Adjust the position of the nail holder to
correspond with the nail length. The nail
will not feed smoothly if the nail holder is
not correctly adjusted.
①
Turn the nail holder about 90°
counter-clockwise.
②
Move the nail holder up and down to align
the plate of the nail holder with the mark on
the magazine that correspond with the
length of the nails being used.
③
Turn the nail holder 90° clockwise until
you hear “click” (Fig. C).
4. Place the nails in the magazine. Insert the
first nail coil into the magazine opening.
①
Uncoil enough nails to reach the driving hole.
②
Insert the first nail into the driving hole and
the second nail between the two pawls of
the feeder.
③
Fit the nail heads in the guide slot.
④
Pull the nails to the right. After checking
and making sure that the magazine cover is
closed, hook your fingers on the nail guide
and knob, turn the nail guide clockwise while
pressing the knob downward, and then close
the nail guide completely.
⑤
Lock the knob completely (Fig. D).
2. Grip the nail guide and knob with finger.
Press the knob down, swing the nail
guide open and open the magazine cover
(Fig. B).
2
1
Fig. A
Fig. B
Fig. C
Fig. D
model no. 058-9816-0 | contact us 1-800-689-9928
First Nail
Driving Hole
Guide Surface
Guide Slot
Feeder
Pawl
Nail Guide
①
4
3
2
