MasterCraft 058-9312-8, Инструкция по эксплуатации

Страница: 93 / 99

MAINTENANCE
17
AIR-POWERED FULL-SIZE DIE GRINDER 058-9332-0
• Air - operated tools must be inspected periodically, and worn or broken parts must be replaced
in order to keep tools operating safely and efficiently.
• Inspect and replace worn or damaged O - rings, seals, etc. Tighten all screws and caps
frequently in order to help prevent personal injury.
• Loss of power or erratic action may be due to the following
- Excessive drain in the air line.
- Moisture or restriction in the air pipe.
- Incorrect size or type of hose connector. Check the air supply and follow instructions.
- Grit or gum deposits in the Die Grinder may also reduce performance.
• Inspect the trigger, the spring, and the safety mechanism for free movement on a regular
basis in order to ensure that the safety system is fully functional.
• Verify that no part is loose or missing and that no part is stuck or jammed.
• Disconnect the tool from the air supply, clean, and store it in a safe, dry, and childproof
location, when tool is not in use.
• When temperatures are below freezing, keep tools as warm as possible using any safe,
convenient method.
• Check the air supply for correct size and type of hose connectors. To avoid loss of power or
erratic action, ensure that there is no additional drain on the air line and no moisture or
restriction in the air pipe.
Storage
• Apply an ample amount of lubrication before storing the tool.
• Run the tool for approximately 30 seconds after lubricating, in order to ensure that the
lubrication is uniformly distributed throughout the tool.
• Store the tool in a clean and dry environment.