MasterCraft 058-8489-4, Инструкция по эксплуатации

Страница: 24 / 30

TROUBLESHOO
TING
24
AIR
-
POWERED 3
-
IN
-
1 NAILER 058
-
8489
-
4
Note: For further repair information, please call 1
-
800
-
689
-
9928.
The tool does not
operate properly
–
it
does not drive the
fasteners or operates
sluggishly.
1. The air supply is inadequate.
2. Lubrication is inadequate.
3. The O
-
rings or seals are worn or
damaged.
4. The air deflector in the cylinder
head is blocked.
1. Verify that the air supply is adequate.
2. Pour up to 6 drops of oil into the air inlet.
3. Inspect and replace O
-
rings or seals.
4. Replace the damaged internal parts.
The tool skips
fasteners.
1. The bumper is worn or the
pusher spring is damaged.
2. There is dirt in the front plate.
3. Fasteners are not moving freely in
the magazine due to dirt or
damage.
4. The O
-
ring on the piston is worn
or damaged.
5. The cylinder cover seal is leaking.
1. Replace the bumper or pusher spring.
2. Clean the drive channel on the front plate.
3. Clean the magazine.
4. Replace the O
-
ring.
5. Replace the sealing washer. Have the tool
serviced by a qualified service technician.
The tool jams.
1. Improper fasteners are being
used, or fasteners are damaged.
2. The driver guide is damaged or
worn.
3. The screw of the magazine is
loose.
4. There is dirt in magazine.
1. Change and use the proper fasteners: 16
gauge finishing nails, 18 gauge brad nails, or
18 gauge staples, ensuring that the fasteners
are installed in the magazine at the correct
location. Fasteners installed improperly may
cause jams.
2. Inspect and replace the driver guide.
3. Tighten the magazine screw.
4. Clean the magazine.
Air exhaust is being
directed towards the
operator.
The direction of the exhaust vent
requires adjustment.
Direct the exhaust vent away from the operator.
PROBLEM POSSIBLE CAUSES SOLUTIONS