14
15
model n
o. 058-8194-4 | contact us 1-800-689-9928
WARNING!
1 BEFORE EACH USE, inspect the general condition of the Plasma Cutter. Check for:
• loose hardware
• damaged cord/electrical wiring
• cooling fan operation
• cracked or broken parts
• any other condition that may affect its safe operation. Have
a qualified technician correct
any problems before operation.
2 MAINTAIN TORCH COMPONENTS BEFORE EVERY USE AND AFTER EVERY HOUR OF OPERATION.
Make sure Torch is completely cool, then:
a. Disassemble Torch.
b Inspect the cutting tip.
Replace if interior is damaged, or if opening is enlarged
or gouged. Clean inside as needed with
steel wool, (remove any pieces of steel wool afterwards).
c Inspect the electrode. Replace if pitted 1/16" or more or
if misshapen.
IMMEDIATELY REPLACE WORN COMPONENTS..
d Make sure all other internal torch components are undamage
d, clean, and free of debris.
e NOTICE: Assemble electrode just snug using the included wrench, but do not over tighten.
f Insert the Swirl Ring and Cutting Tip into the torch.
g Assemble the Retaining Cup tightly.
3 Attach the Drag Cup (cutting guide) to the end of the Torch
so that its guides are parallel to the cutting
path. It drags on the workpiece to keep the distance from th
e Torch to the workpiece constant for longer
Cutting Tip life.
Note: For clarity, the Drag Cup is not shown in the followin
g illustrations.
4 Securely attach the Ground Clamp to a part of the workpiece or metal work table that is clean,
dry, and free from paint, oil, or dirt. Clamp as close as possible to the planned cut without exposing
the Clamp to damage.
model n
o. 058-1294-8 | contact us 1-800-689-9928
model n
o. 058-1294-8 | contact us 1-800-689-9928
model n
o. 058-1294-8 | contact us 1-800-689-9928
PLASMA ARC CAN CAUSE SERIOUS INJURY.
INCLUDING SEVERE CUTS, BURNS, PERMANENT EYE DAMAGE AND BLINDNE
SS!
Once the trigger is squeezed, the arc will ignite IMMEDIATELY.
The torch does not need to contact the workpiece before the pil
ot arc ignites.
Do not look at the plasma arc without an ANSI-approved welding helmet featuring at least a number
10 shade lens rating.
Electrode
Swirl Ring
Cutting Tip
Retaining Cup
Drag Cup
DO NOT USE WITH WORN COMPONENTS,
USING WORN COMPONENTS WILL VOID THE WARRANTY AND DAMAGE THE
PLASMA CUTTER.
OERATING INSTRUCTIONS
5 When everything is in place for cutting, set the Power Switch to the On position. The green Power
Light will illuminate, but the Torch is not yet energized.
6 Orient yourself to one side of the cutting area, and move the Welding Helmet (sold separately) over
your eyes.
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
Model no. 058-1929-0 | contact us 1-800-689-9928