MasterCraft 054-8363-0, Инструкция по эксплуатации

Страница: 13 / 17

headline bars
continuation tabs
notes
warnings
25
headline bars
continuation tabs
notes
warnings
model no. 054-8363-0 | contact us 1.800.689.9928
24
MAKINg A beVeL CUT (fig 16)
1. Secure workpiece with clamps.
2. Draw a line of cut on the workpiece.
3. Unplug the saw.
4. Adjust and secure the saw at desired bevel angle.
5. Connect the power cord of your circular saw to a standard household power outlet.
6. When making a bevel cut, hold the saw firmly with both hands.
7. Rest the front edge of the base on the workpiece. Depress the trigger switch to start the saw. Allow the
saw to reach full speed before attempting to make a cut.
8. After completing the cut, release the trigger switch and allow the blade to come to a complete stop. After
the blade has stopped, remove the saw from the workpiece.
fig 16
Line of cut
45 ° indicator
MAINTeNANCe
befORe eACH USe
1. Inspect the circular saw, the trigger switch, the cord and the accessories for damage.
2. Check for damaged, missing, or worn parts.
3. Check for loose screws, misalignment or binding of moving parts, or any other condition that may affect
the operation.
4. If abnormal vibration or noise occurs, turn the tool off immediately and have the problem corrected before
further use.
Unplug the tool from power source before cleaning or performing any maintenance. Using compressed air may
be the most effective cleaning method. Always wear safety goggles when cleaning tools using compressed air.
NOTICe:
There is a notch in the saw base to help you line up the blade with the line of cut when making
45° bevel cuts. Align your line of cut with the center of the notch by the 45° indicator.
wARNINg!
• Do not allow brake fluids, gasoline and petroleum-based products, penetrating oil, etc.
come into contact with plastic parts. These substances contain chemicals that can
damage, weaken, or destroy plastic.
• When servicing, use only identical replacement parts. The use of any other parts may
create a hazard or cause damage to the product.
• Use only accessories that are recommended for this circular saw by the manufacturer.
Accessories that may be suitable for one tool may become hazardous when used with
another tool.
• Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained tools with
sharp cutting edges are less likely to bind, and are easier to control.
• To ensure safety and reliability, all repairs should be performed by a qualified service
technician.
FPO
MAINTENANCE
OPERA
TING
INSTRUCTIONS