MasterCraft 054-6962-6, Инструкция по эксплуатации

Страница: 15 / 20

headline bars
continuation tabs
notes
warnings
15
REPLACING THE CUTTING BLADE (See Fig. D)
After considerable use, the cutting blade will become worn
and will have to be replaced. The following instructions detail
how to remove and replace cutting blade.
1. Remove the screw (a3) with the hex key ensuring you do
not lose the two short spacers (d1, d2).
2. Remove all the three old blades (e1, e2, e3) and install
new ones.
Fig. A
Fig. C1
Fig. C2
Fig. D
Fig. B
3
4
a1
a2 a3
d1
e1
e2
a3
d2
e3
OPERA
TING INSTRUCTIONS
FPO
WARNING!
Blade teeth are very sharp. Wear productive gloves when replacing the cutting blade.
FPO
WARNING!
Remove the plug from the power source before replacing the cutting blade.
NOTE:
The right blade (e1) has two slotted holes; left blade (e2) has one, The right blade (e1) has two
slotted holes; left blade (e2) has one slotted hole and one round hole.
•
Make sure the blade screw (a3) is properly located in the swivel head before tightening, but
do not over-tighten.