ROUTER TABLE - 054-6938-6
8
Guidelines for extension cords
• When operating a power tool outdoors, use an outdoor extension cord that is marked W-A
or W.
These cords are rated for outdoor use, and reduce the risk of electric shock. Replace damaged
cords immediately. Using a damaged cord can cause shocks, burns, or electrocution.
• Use a proper extension cord.
Make sure that extension cords are in good condition. When using
an extension cord, be sure to use a cord that is heavy enough to carry the drawn current needed by
the router and accessories. An undersized cord will cause a drop in line voltage, resulting in loss of
power and overheating. The table below shows the correct size to use, depending on the cord length
and nameplate amperage rating. If in doubt, use the next heavier gauge. The smaller the gauge
number, the heavier the cord.
• Be sure that extension cords are properly wired
and in good condition.
Always replace
a damaged extension cord or have it repaired by a qualified technician before using it. Protect
extension cords from sharp objects, excessive heat, and damp or wet areas.
• Use a separate electrical circuit for power tools.
This circuit must not be less than #6 wire,
and should be protected with a time-delayed fuse. Before connecting the tool to the power line,
make sure the switch is in the OFF position and the electric current is rated the same as the current
stamped on the motor’s nameplate. Running at a lower voltage will damage the motor.
WARNING!
Ensure that the power supply outlet in question is properly grounded. If not sure, have a
licensed electrician check the outlet.
WARNING!
To avoid electrical hazards, fire hazards, or damage to the tool, use proper circuit
protection.
Specific safety rules for the router table
WARNING!
Read all instructions. Failure to comply with all of the following instructions may result in
electric shock, fire and/or serious injury.
• Read and understand all instructions and warnings in the Instruction Manual for the
router table and the router used with this table.
Failure to follow all instructions and warnings
may result in serious personal injury.
• Fully assemble and tighten all fasteners required for this table and for mounting the
router to the table.
Do not use the router table until all assembly and installation steps have been
completed.
SAFETY GUIDELINES
Содержание 054-6938-6
Страница 1: ...INSTRUCTION MANUAL ROUTER TABLE 054 6938 6...