MasterCraft 054-4289-2, Инструкция по эксплуатации

Страница: 14 / 22

headline bars
continuation tabs
notes
warnings
14
model no. 054-4289-2 | contact us 1-800-689-9928
LED WORKLIGHT (fig 8)
The LED worklight will illuminate when the trigger
switch is pressed. This provides additional light on
the surface of the workpiece for operation in lower
light situations.
STRAIGHT CUTTING (fig 9)
A straight cut can be made by clamping a piece of
wood or a straight edge to the workpiece and guiding
the edge of the saw against it. Make the cut from one
direction only. Never cut halfway and then complete
the cut from the opposite end.
The straight cut can be also made by using the edge
guide supplied with this tool.
GENARAL CUTTING
1. Firmly clamp the workpiece in place.
2. Use the appropriate type and size of blade for the
workpiece.
3. Check the clearance behind the workpiece and assure that the blade will not impact another surface.
4. Clearly mark the line of the cut.
5. Hold the saw firmly. Make sure that your hand is on the insulated gripping areas only.
6. Rest the base plate on the workpiece so that the blade is not in contact with the workpiece.
7. Turn on the jigsaw and bring it to the maximum desired cutting speed before applying the blade to the
workpiece.
8. Slowly move the jig saw into the workpiece.
9. Do not force the tool. Keep the base plate flat against the workpiece while cutting. Use only enough steady
pressure on the blade to keep the saw cutting.
10. Reduce pressure as the blade comes to the end of the cut.
11. Allow the saw to come to a complete stop before removing the blade from the workpiece.
12. If sawing fiberglass, plaster, wallboard, or spackling compound, clean the saw motor vents frequently with
a vacuum or compressed air. Always wear safety goggles when cleaning tools using compressed air. These
materials are highly abrasive and may accelerate the wear on motor bearings and brushes.
OPERA
TING INSTRUCTIONS
WARNING!
• Allow the blade to come to a complete standstill before setting the jigsaw down.
FPO
fig 9
fig 8
LED Worklight