MasterCraft 054-2502-6, Руководство пользователя, Страница: 9 / 17

9
TRIGGER SWITCH
– cont’d
LED LIGHT
The LED light (1) will illuminate the immediate
work area (Fig 5). To turn the LED light ON,
press the LED switch (2) once. To turn the LED
switch OFF, press the LED switch a second
time.
NOTE: Make sure you turn the LED switch OFF
when the LED light is not in use to prevent the
battery from being run down.
PREPARING SCREW HOLES
NOTE : Use conventional drill bits and drill to drill
screw holes.
It is important to prepare screw holes before
attempting to fasten two pieces of wood
together. Proper preparation will make screws
drive more easily and prevent misaligned
components, stripped screw heads, splitting and
separating of wood components.
1.
Clamp components that are to be screwed
together in their desired position (Fig. 6).
2. Drill a pilot hole (1) through the outer piece
(2) and into the inner piece (3). Pilot hole
drill bit should be 2/3 the diameter of the
smooth portion of the screw shank.
NOTE: If the wood is soft, drill the hole 2/3 the
length of the screw. If the wood is hard, drill the
hole the full length of the screw.
3.
Remove the clamp from the two pieces to
be screwed together.
4. Enlarge the hole (1) in the outer piece (2)
so it is the same size as the smooth portion
of the screw shank (Fig. 7).
5.
If using a flat head screw, counter-sink the
hole (4) so the head of the screw will be
flush with the surface when it is fully driven
into place.
ASSEMBLY & OPERATION
Fig. 4
Fig. 6
Fig. 5
Fig. 7