MasterCraft 054-2502-6, Руководство пользователя, Страница: 10 / 17

10
INSTALLING SCREWDRIVER BITS
WARNING: Never hold the screwdriver
with your fingers near the switch while
changing screwdriver bits. Accidentally
touching the switch may start the tool and
possibly cause an injury.
1.
Select an appropriate screwdriver bit that
fits the head of the screw being driven.
NOTES:
a) Use the largest size screwdriver bit that will
properly fit the screw head.
b) Make sure the screwdriver bit is in good
condition and is neither damaged nor worn.
2.
Insert the screwdriver bit (1) fully into the
magnetic bit holder (2) (Fig 8).
NOTE: Make sure the screwdriver bit is fully
inserted into the magnetic bit holder until it is
held in place by the magnet.
DRIVING SCREWS
When driving screws, care must be taken to use
the bit that correctly fits the head of the screw
being driven. Make sure to use the largest bit
size that will properly fit into the head of the
screw. The bit must also be in good condition
and not worn so it will drive screws without
slipping out of the screw head.
1.
Select the correct screwdriver bit for the
screw being driven.
2. Insert the bit (1) fully into the bit holder (2)
(Fig. 9).
3. Set the rotation direction switch (3) so the
screwdriver bit is turning clockwise.
4. Insert the screwdriver bit fully into the
screw head (4).
!
ASSEMBLY & OPERATION
!
Fig. 8
WARNING:
Read "POWER TOOL
SAFETY", "SPECIFIC SAFETY RULES",
"BATTERY & CHARGER SAFETY" and
"SYMBOLS" on pages 2 through 6 of this
manual before operating this cordless
screwdriver.
Every time the pivoting screwdriver is used,
the following should be verified
:
1. Screwdriver bit is the correct type
and size, not worn and not damaged
in any way.
2. Workpiece is properly secured.
3. Safety glasses are being worn.
Failure to adhere to these safety rules
can greatly increase the chances of injury
or property damage.
!