MasterCraft 054-1250-0, Руководство пользователя

Страница: 17 / 24

17
CHANGING THE COLLET
Some accessories require the use of
different sized collets. Collet sizes can be
1
/
16
”,
3
/
32
” and
1
/
8
”. It is important to ensure
that the collet size matches the accessory.
NOTE: This tool includes the most
commonly used collets:
1
/
16
”,
3
/
32
” and
1
/
8
”.
WARNING:
Using a collet that is
too large for the accessory will result in
the accessory possibly being thrown
from the tool causing serious injury.
1. Turn the tool switch OFF and remove
the plug from the power source.
2. Depress the spindle lock button (1) and
slowly turn the collet nut (2) until the
spindle lock button locks the spindle
(4) (see Fig. 2).
3. While holding the spindle lock button
down, turn the collet nut counter
clockwise until it is removed.
4. Remove the collet (3) by pulling it out
of the spindle.
5. Insert the replacement collet into the
spindle and replace the collet nut by
turning it clockwise while holding the
spindle lock button down.
NOTE: Do not tighten the collet nut
without an accessory installed in the
collet. You will damage the collet.
INSTALLING ACCESSORIES
1. Turn the switch OFF and disconnect
the tool from the power source.
2. Depress the spindle lock button (1) and
slowly turn the collet nut (2) until the
spindle lock button locks the spindle
(see Fig. 3).
3. While holding the spindle lock button
down, turn the collet nut counter-
clockwise until the collet is loose inside
the collet nut.
4. Insert accessory (3) into collet.
NOTES:
a) Make sure the correct collet is used
for the accessory. If collet is too large,
replace the collet with the next smaller
size.
b) Insert accessory at least
3
/
4
" into the
collet.
5. Press the spindle lock button and
engage it in the spindle. While holding
the spindle lock button down, hand-
tighten the collet by turning it
clockwise.
NOTE: Do not use pliers to tighten the
collet nut. Use the small wrench (4)
supplied. Over tightening will cause
damage to the tool.
6. Pull on the accessory to ensure it is
securely in place.
ASSEMBLY & OPERATION
!
Fig. 2
Fig. 3