Entrée Bath Gen III
INSTALLATION MANUAL
01-27-2022
Page 8 of 9
450 East 32
nd
Street PO Box 1022 (68026)
Fremont NE 68025
800-798-5867 Office: 402-564-5867 FAX: 402-563-9102
www.mastercarebath.com
13.
Tighten the hose clamps on the rubber couplers.
14.
Anchor the tub to a concrete section or to a stud floor.
15.
Proceed to the Operation Manual
16.
Go through a bath cycle and verify all functions work correctly.
17.
Make sure that when the fill knob is in the hot position, hot water
comes out of the valve.
Check the water temperature and verify it is
in the proper range. Rotate the knob to mid range and verify the
temperature "tracks the knob" and reduces accordingly.
Note: If the hoses are connected backwards, the mixing valve will not
function correctly.
18.
Check the GFCI
, located at the Service End under the Electrical Service
Door, and make sure it trips and resets properly.
19.
Make sure the tub is grounded according to code.
Shower Knob
Mixing Valve
GFCI
Located at the
Service End
under the
Service Door
