MASTERBLEND MASTERFORCE, Руководство по эксплуатации и техническому обслуживанию

Страница: 5 / 30

4
MASTERFORCE
®
WASTE TANK FILTER BAG
The waste tank filter bag should be cleaned out after every
job. This filter bag will catch the larger debris and most lint.
The filter bag is attached by a drawstring. Loosen the draw-
string, clean the filter bag, and reinstall. Never operate the
MasterForce without the filter bag in place.
VAC SHUT OFF
The MasterForce utilizes a ball float shutoff system, which
shuts off the flow to the vacuum motors when solution
reaches the appropriate level to activiate the ball shutoff. This
shutoff has been designed to protect the vacuum motors from
excess water entering the vacuum motors
provided that the
owner is utilizing a defoamer chemical to prevent foam
and moisture from entering the vacuum stack and,
therefore, the vacuum motors.
Twist off the ball assembly from the stand pipe, and clean
the screen. It may be rinsed with water. This screen should
be cleaned frequently if the MasterForce is being operated in
an environment which has an abnormal buildup of lint and
debris, such as cleaning newly installed carpet. Loss of vac-
uum is most normally associated with lint and hair buildup in
the waste filter bag and the float ball shutoff assembly at the
top of the vacuum stand pipe.
AUTO PUMP-OUT
(If Equipped)
The Automatic Pump-Out system is capable of handling
most debris that passes through the waste filter bag. How-
ever, for optimum performance, keep the waste tank clean
and remove debris from the filter screen of the pump-out.
This should be done on a daily basis, or as needed, depending
upon use, and amount of debris.
Every two weeks, run the pump-out with a full tank of
clean water, to insure that debris and lint are not accumulat-
ing in the base of the pump.
To service the pump-out more thoroughly, unhook the vac-
uum cuff, cut the zip tie around the looped electrical cord,
and lift it out of the waste tank. Unsnap the screen from the
bottom, clean the screen, and clean out the area inside.
If necessary, remove the six screws holding the base to the
motor housing, and clean the base. If the impeller is removed
make sure that a spacing of .050” with shaft pushed toward
housing is maintained when reassembled.
GREASE PUMP
- For 503 & 1203 models with Hypro Pump
Refer to “ACCESSING COMPONENTS,” above, to gain
access to pump. remove the white safety cap at the front of
pump exposing the grease fitting. Grease pump with only a
OPERATION INTERVAL
Clean Fill Hose Screen Each Job/Daily
Clean Chemical Feed Foot Valve Each Job/Daily
Clean Fresh Water Filter Weekly
Clean Waste Tank Filter Bag Each Job/Daily
Clean Vac Shut Off Screen Daily
Clean Auto Pump-out Daily As Needed
Clean Wand Jets Weekly
Run Auto Pump-out Every Two Weeks
Flush Solution System Monthly
WD-40 Vac Motors As Needed
Grease Pump Monthly
The above operations are fully outlined on the following two pages. Proper maintenance is necessary to
achieve maximum operating performance from your MasterForce. Failure to properly maintain your
machine could void the warranty.
Maintenance
MasterBlend (800) 525-9644