MASTERBLEND MASTERFORCE, Руководство по эксплуатации и техническому обслуживанию

Страница: 6 / 30

5
1/4 stroke of grease gun Too much grease or too much pres-
sure will blow out the bearing seal. Over greasing will break
seal. Once this seal is broken, no amount of grease will stay
the bearing, voiding pump warranty. Use a quality, high tem-
perature bearing grease. Wipe away excess grease and
reinstall safety cap.
WAND JETS
Remove jets and visually check for wear and debris. Water
or compressed air is best for cleaning—NEVER use a metal
object to remove debris, as it may damage the jet orifice. If
excessive wear is apparent, the jet should be replaced. If the
wand is equipped with jet screens, those should be cleaned by
rinsing with water. Hook up the wand to machine, and check
jet alignment.
FLUSH SOLUTION SYSTEM
At least once a month, the MasterForce, hoses, and tools
should be flushed to remove alkaline residues. Follow the
steps on page 6 of the “Recommended Procedure for Stor-
age,” using a solution of one part warm water with three
parts white vinegar, in place of the antifreeze solution. Then,
repeat the steps using two gallons of fresh water.
WD-40 VAC MOTORS
Should moisture ever enter the vacuum motors, completely
drain the waste tank, open the waste tank lid, remove the vac
shut off ball assembly, turn on all vacuum motors, and spray
a five second burst of WD-40 into the standpipe. Continue to
run the vacuum motors for at least three minutes.
To prevent moisture from damaging the vacuum motors dur-
ing storage, empty the waste tank and store with the lid open.
MASTERFORCE
®
MasterBlend (800) 525-9644