7
Machine Elements
The numbering of the machine elements refers to the
illustration of the machine on the graphics page.
1
Keyless chuck
2
Spanner surface
3
Auxiliary handle collar
4
Ventilation slots
5
Rotational direction switch
6
Lock-on button
7
Torque-Control thumbwheel
8
Latch for mains cable module
9
On/Off switch
10
Speed selector thumbwheel
11
Auxiliary grip
Not all of the accessories illustrated or described are included
as standard delivery.
Intended Use
The drill can be used for drilling in wood, metal and
plastics and for screwdriving.
The user is responsible for damage caused by usage
other then intended.
Noise/Vibration Information
Measured values determined according to
EN 60 745-1.
Typically the A-weighted sound pressure level of the
product is 73 dB (A). The noise level when working can
exceed 85 dB(A).
Wear hearing protection!
The typical hand/arm vibration is below 2.5 m/s
2
.
Working safely with this machine is pos-
sible only when the operating and safety
information are read completely and the
instructions contained therein are strictly
followed. In addition, the general safety
notes in the enclosed booklet must be observed.
Before using for the first time, ask for a practical
demonstration.
The unit must not be damp and must not
be used in a wet environment.
Wear hearing protection.
Exposure to
noise can cause hearing loss.
❏
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
The power tool is guided more secure with
both hands.
❏
Secure the workpiece.
A workpiece clamped with
clamping devices or in a vice is held more securely
than by hand.
❏
Do not work materials containing asbestos.
Asbestos is considered carcinogenic.
❏
Always wait until the machine has come to a
complete stop before placing it down.
The tool
insert can jam and lead to loss of control over the
power tool.
❏
Hold the machine with a firm grip.
High reaction
torque can briefly occur while driving in and loos-
ening screws.
❏
Do not use a machine with a damaged mains
cable. Do not touch the damaged cable and pull
the mains plug when the cable is damaged while
working.
Damaged cables increase the risk of an
electric shock.
❏
Connect machines that are used in the open via a
residual current device (RCD).
❏
Always use the auxiliary handle supplied with
the machine.
Loss of control can cause personal
injury.
❏
Use suitable detectors to determine if utility lines
are hidden in the work area or call the local util-
ity company for assistance.
Contact with electric lines can lead to fire and elec-
tric shock. Damaging a gas line can lead to explo-
sion. Penetrating a water line causes property
damage or may cause an electric shock.
❏
Hold the machine only by the insulated gripping
surfaces, when performing an operation where
the cutting tool may run into hidden wiring.
Con-
tact with a “live” wire will make exposed metal
parts of the tool “live” and shock the operator.
❏
Use only original Würth parts and accessories.
For Your Safety
☞
For further notes on safety refer to the enclosed sheet
GB
BS 13-SEC.book Seite 7 Mittwoch, 2. Februar 2005 3:32 15
Содержание BS 13-SEC
Страница 2: ...A B 1 2 3 4 5 6 7 8 9 10 11 ...
