LAYOUT
1. Carrying handle
2. Mains cable
3. Pump casing 11
4. Pump pedestal
5. Pump output
6. Float switch
7. Terminal box
8. On/Off switch
9. Overload protection
10. Battery
11. Charger
INSTALLATION
Stationary
- With a fixed pipeline
- With a flexible hose line Hang the pump on the carrying handle or on the bottom of the shaft, but never
hang it by the cable or pressure hose.
The bottom of the shaft must always be free of sludge or other impurities and have dimensions of at least
40 x 40 x 50 so that the float switch can move freely.
Check that the float switch is working .
Make sure that the pressure line is properly attached.
The pump is ready to operate when it is connected to the terminal box.
CLEANING THE IMPELLER
In case of impurities in the pump casing, the lower part of the pump must be dismantled as follows:
1. Remove the 3 screws on the lower side of the suction cage.
2. Remove the suction cage from the pump casing.
3. Clean the impeller with clear water.
4. Reassemble in the reverse order.
Make sure that you don’t put the pump down on the impeller
OPERATION
Insert / remove rechargeable battery Switch off the apparatus. Before you insert the battery in the
machine, you must insert the battery pack in holder first.
1. To insert the battery , push the battery along the guide rail into the appliance. It locks into place audibly.
2. To remove the battery from the appliance, press the release button and pull the battery out.
