NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A POWER SOURCE
© 2018 Pinnacle Climate Technologies, Inc.
Kerosene Forced Air Heater User’s Manual
9
MAINTENANCE
Long Term Storage:
1. Drain fuel through the drain bolt in the bottom
of the fuel tank.
2. To remove the drain bolt, unscrew
counterclockwise (see Figure 5).
3. Using a small amount of kerosene, rinse and
swirl the kerosene inside of the fuel tank,
empty the tank fully.
4. To replace the drain bolt, insert the drain head
fully into the drain hole and screw clockwise.
IMPORTANT: Never store leftover kerosene/diesel
between seasons; using old fuel can damage the
heater.
Service:
DO NOT TAMPER WITH THE UNIT. HAVE
A COMPETENT SERVICEMAN MAKE ANY
NECESSARY ADJUSTMENT OR REPAIRS.
Use onl
y original equipment parts. The use of
alternate or third party components can cause unsafe
operating conditions and will void your warranty.
We suggest following a maintenance schedule as follows:
FUEL / FUEL TANK:
Flush tank every 200 hours of operation or as needed.
DO NOT flush with water, use fresh K-1 kerosene only.
AIR FILTERS:
The air intake filter should be replaced or washed
with soap and water and dried thoroughly every 500
hours of operation or less depending on conditions.
The output and lint filters should be replaced
every 500 hours of operation or less depending
on conditions (see Figure 6).
NOTE: Use of diesel fuel may require additional
maintenance
Air Output Filter
Intake Filter
Lint Filter
End Filter
Figure 6
TIP: To order OEM parts call 800-641-6996
TIP: Follow the long term storage
instructions to flush the tank.
Never service heater while it is
plugged in or hot!
WARNING
Drain Bolt
Figure 5