Master Chef 085-3250-4, Руководство пользователя

Страница: 18 / 33

18
Leak Testing
Product no. 085-3250-4 (TF2201804-MC) |
Contact us: 1-855-803-9313
GENERAL
Although all gas connections on the appliance are leak tested at the factory prior to shipment, a complete gas tightness check
must be performed at the installation site due to possible mishandling in shipment, or excessive pressure unknowingly being
applied to the unit.
Periodically check the entire system for leaks following the procedures listed below. Before using your appliance you must
check for leaks.
BEFORE TESTING
Make sure that all packing material is removed from the appliance.
Make a soap solution of one part liquid detergent and one part water. You will need a spray bottle, brush, or rag to apply the
solution to the fittings. For the initial leak test, make sure the LP cylinder is full.
WARNING:
• DO NOT SMOKE WHILE CONDUCTING LEAK TEST.
• NEVER PERFORM LEAK TEST WITH AN OPEN FLAME.
• If it is evident that there is excessive abrasion, wear or the hose is cut, it must be replaced prior to
the appliance being put into operation. The replacement hose must be specified by the
manufacturer.
TO TEST
1. Make sure the control valve is in the OFF position then turn
on the gas supply.
2. Check all connections from the gas cylinder, LP gas regulator
and supply valve up to and including all connections to the
pipe that go to the burner. The following are the points where
the soap-water mixture is to be applied. Soap bubbles will
appear if a leak is present.
A. Supply tank (cylinder) weld.
B. Tank valve to cylinder.
C. Tank valve knob.
D. Regulator coupling nut to tank valve.
E. Regulator to regulator coupling nut.
F. Regulator connections to gas supply hoses.
G. The full length of gas supply hose.
H. Burner valve stem cap.
I. Hose connection to burner valve.
J. The full length of corrugated tube.
3. If a leak is present, immediately turn off the gas supply and tighten the leaky fittings.
4. Turn the gas back on and recheck.
5. Should gas continue to leak from any of the fittings, turn off the gas supply and contact the customer service department.
Watch For Bubbles
C
D
E
A
H
B
F
G
I
J