Model no. 043-1297-6 | Contact us: 1-855-803-9313
9
8
TM
1. This Induction Cooktop will only operate with suitable cookware.
The most common types are cast iron, enameled and stainless steel. The Induction Cooktop will not operate
when using aluminum, ceramic, copper, glass and Pyrex
©
or cookware that has a concave bottom.
2. If the Induction Cooktop has been turned on without a compatible pot in place, the unit will beep for
approximately 30 seconds and the error code E1 will be appear in the Display Window. Then the unit will shut off
automatically.
3. The unit will automatically turn off is the voltage rises over 150 V or drops to less than 80 V.
4. When the unit is off, the fan may continue running until the temperature of the Induction Cooktop is below
120°F (50°C).
5. NEVER heat empty cookware. This will cause the unit to overheat, damage the cookware and/or cause the unit
to shut off.
Err
or Codes
NOTE:
Cookware should have a diameter no less than 12 cm (4 3/4”) or more than 20 cm (8”)
in order to work correctly. If the cookware is larger than the circular cookware placement guides
indicated on the Induction Cooktop, the area outside these guides will not work causing an
inconsistent heating pattern.
1) Unplug from the wall outlet.
2) Clean the Induction Cooktop and the Control Panel with a damp cloth.
3) Dry with a soft cloth.
4) Clean the unit after each use.
5) All servicing, other than cleaning, should be performed by an
authorized service representative. See Warranty section.
NOTE:
1. Do not use a brush or abrasive cleansers. This may damage the Cooktop.
2. Do not immerse the unit in water or any other liquid.
Error Code
(see digital display)
Reason
Solution(s)
E0, E2, E5, E6 & E7
Internal Circuit Error
Parts are either overheating or
have an open or short circuit
• See 'Warranty' section
in this instruction booklet
for contact information.
E1
Cookware Sensor Detection
• Check whether or not
cookware is suitable.
• Make sure the
cookware is within
the circular cookware
placement guides
indicated on the
Induction Cooktop.
• Cookware was
removed during cooking.
Replace cookware back
on Cooktop.
E3
Incorrect Voltage Sensor
- Voltage over 150 V
• Make sure the outlet
used is 110/120 V AC.
E4
Incorrect Voltage Sensor
- Voltage below 80 V
• Make sure the outlet
used is 110/120V AC.
Import
ant No
tes
Car
e and Cleaning
