6/16 Rev. A 57-02502 6
6.
Level and square the case as needed by adjusting the leg leveler in each corner of base. (Use the
wrench provided.) (The case must be level for proper drainage of defrost condensate to the
condensate evaporator and allow for proper alignment of front glass.) The 59”, & 77” cases also
have a set of leg levelers in the center. These must be adjusted so the base is flat.
7.
The leveled case must be sealed to the floor using a NSF Listed Sealant.
Grill Removal (Refrigerated Units)
There is a removable slotted panel at the rear of the case. The panel allows access to the
condensing unit, the light ballast, the condensate pan, and the field wiring connection box.
Remove this panel to make field wiring connections. See electrical information and grounding
section of this manual before wiring case.
Note: If electrical connection has been performed, disconnect power to case before removing grill panel.
1.
Remove the rear grill panel screws from top of rear grill.
2.
Tilt the top of rear grill panel outward as shown in illustration on the right.
3.
Pull rear grill panel tabs up and out of slots in base of case.
2.
1.
REAR GRILL
PANEL SCREWS
3. REAR GRILL
PANEL TABS
E1954-7
DANGER:
Electric shock hazard. Do not operate unit with panels removed.