6/16 Rev. A 57-02502 12
INSTALLATION
REMOVAL
SHELF STANDARD
TOP HOOK
1
SHELF BRACKET
2
3
BOTTOM TAB
4
12° NOTCH
6° NOTCH
0° NOTCH
A.. Place shelf bracket top hook into desired shelf
standard slot.
B. Lift shelf bracket top hook to allow shelf bracket
bottom tab to clear shelf standard slot.
C. Swing shelf bracketbottom tab into shelf standard
slot.
D. Place the desired shelf bracket notch of 0, 6, or 12
degrees onto bottom of shelf standard slot.
A. Lift shelf bracket up to allow shelf bracket notch
to clear the bottom of shelf standard slot.
B. Swing shelf bracket bottom tab out of shelf
standard slot.
C. Drop shelf bracket down to allow shelf bracket top
hook to clear top of shelf standard slot.
D. remove shelf bracket top from shelf standard slot.
3.
Hang one end of shelf light housing on the front notch of a shelf bracket and then the other end of
shelf light housing on the notch of the shelf bracket on the opposite end. Repeat for each additional
shelf tiers
4.
Push shelf light cords into clear plastic clip located on inside of shelf brackets.
5.
Remove the cap from the appropriate female light sockets. If socket is not being used for a shelf
light, the cap must be plugged into socket for entire light system to operate. NOTE: Grip each side
of cap firmly and wiggle and pull cap straight out of socket. Do not roll cap during removal.
RIGHT
WRONG
6.
Plug in each shelf light by aligning the male pins on the appropriate shelf light cord plugs with the
female light sockets and push together. NOTE: Do not roll plug during insertion.
1
2
3
4
E1954-3
