4
Washer & Nut
for this bolt on
inside of chute.
M8 X 20 Screws
+ spring washers
+ plain washers
Shredder chute
Chipper chute
Belt Guard
Axle clip
+ washer
Front legs
Bolt head
Fig.2
1. Obtain and wear safety glasses at all times
while
operating
the
machine.
Hearing
protection is also recommended, especially
for extended operating periods.
2. Avoid wearing any loose fitting clothing.
3. Before starting the machine, check that all
screws, nuts, bolts and other fasteners are
properly secured. Replace damaged or
unreadable warning and operating decals.
4. Use extra care in handling gasoline and other
fuels. They are flammable and the vapours
are explosive.
a) Use only an approved container for fuel.
b) Never remove fuel cap or add fuel with
engine running. Allow engine to cool
before refueling. Do not smoke.
c) Never refuel the machine indoors.
d) Never store the machine or fuel container
inside where there is an open flame such
as a water heater
1. Ensure the Chipper Shredder is on stable
level ground so it won’t tip over. Do not
operate the machine on a hard surface such
as concrete, as discharged material will
rebound and may damage people or property.
2. Before starting the engine, check that the
engine mounting plate is roughly horizontal. If
not – see maintenance instructions.
3. Turn switch on side of engine to “ON”
position.
4. Push choke lever to
(choke)
position and throttle lever to fast position.
5. Pull the starting cord until the engine starts.
Push the choke lever to (Run)
