Masport PG33 Gas Inbuilt
33
INSTALLATION
Note: The logs must not be in the unit.
3) Insert the back brick panel by carefully
slipping it between the back wall of the
firebox and the rear log bracket.
OPTIONAL BRICK
PANELS
1) Undo the bottom 2 door latches and open
and remove glass door. Remove logs.
2) Attach the 2 Rear Brick Retaining clips to
the rear wall. Loosen the screws in the top
and rear wall of the firebox and slide the
retaining clips into position (tight against
the firebox top) and then tighten the screws.
4) Put the side panels in next. Slide them in from
the front and push them flat up against the
wall. Be very careful not to scratch them on
the firebox hardware.
5) Slide the Top Brick Panel into position and
slide the Top Brick Retaining clips so that
they hold the Top Brick Panel in place and
tighten down the screws.
LOG SET INSTALLATION
NOTE: If you will be installing the optional
Brick Panels, install the Brick Pan-
els prior to installing the logs.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care - do not force into position.
2) Sprinkle the vermiculite and embers around
the firebox base.
Notch
Bracket
Bracket
250
254
Vermiculite
Vermiculite
Vermiculite
250
254
The 3-digit numbers (i.e. 250) are
molded into the rear of each log.
Read the instructions below care-
fully and refer to the diagrams. If
logs are broken do not use the
unit until they are replaced. Bro-
ken logs can interfere with the
pilot operation.
Log Kit # 431-930 contains the following pieces:
A ) 250
Rear Log
902-250
B) 254
Middle Cross Log
902-254
C) 253
Front Left Cross Log
902-253
D) 251
Rear Left Log
902-251
E) 252
Front Right Cross Log 902-252
F)
Embers
902-156
G)
Vermiculite
902-179/21
H)
Rockwool
902-153
3) Place the Log 250 on the rear log support
pins with the flat side to the back.
4) Place Log 254 on the front right side of the
burner. Push the back of the log against the
2 brackets with the notch on the bottom
right side of the log fitting into the right side
of the grate.
5) Position Log 253 across the cutouts in Logs
250 and 254 with the notch on the left side
of the log fitting into the 2nd grate tab.
Cutouts
2nd Grate Tab
253
250
254
D) 251
A) 250
C) 253
B) 254
E) 252
