Mash Six Hundred 650cc, Руководство пользователя

Страница: 23 / 27

44 45
Back to summary
Adjusting the transmission chain
To adjust:
1. Secure the motorcycle on its side stand or center stand (if equipped).
2. Loosen the nut on the rear wheel axle.
3. Loosen the lock nut.
4. Turn the adjustment bolt left or right to achieve the desired adjustment.
1.Adjustment bolt
2.Lock nut
3. Alignment mark
4. Rear wheel axle nut
Note: When installing a new chain, it is
necessary to check the pinion and crown. It
is advisable to replace the chain kit.
The tension of the drive chain should be
adjusted every 1000 km so that the play is
between 20 and 30 mm.
Caution
The closed (rounded) part of the chain
quick release clip should face the direction
of chain rotation.
1. Quick chain clip
2. Direction of rotation
Cleaning and lubricating the drive chain
The accumulation of dirt on the drive chain can worsen its wear and that of the
sprockets. It is therefore strongly recommended to clean the chain every 1000 km
using a cleaning solvent, then grease it with a special lubricant or engine oil.
Reference: IPONE: Chain Cleaner / X-TREM Chain Road.
Tires
Check the tire pressure and their tread after the first 1000 km, then every 3000
km. In addition to periodic checks, get in the habit of checking tire pressure from
time to time to prolong tire life and ensure maximum safety.
Tire pressure
Insufficient pressure can worsen tire wear and affect vehicle stability: in particular,
changes of direction can be more difficult. Conversely, excessive pressure, by reducing
the contact surface between the tires and the road, increases the risk of skidding or
even loss of control of the vehicle. Therefore, it is necessary for the tire pressure to
remain within the specified limits. The tire pressure should be adjusted when cold,
before driving.
Tread Sculptures
Riding a motorcycle with worn tires compromises its stability and comes with an
increased risk of loss of control. If the tread depth of the front wheel is not sufficient,
it is advisable to have the tire replaced. This operation is also necessary for the rear
tire if the depth of the rear wheel tread is not sufficient.
Warning
As the use of tires other than the standard models can cause problems,
it is strongly recommended that you use tires identical to the original ones.
Compliance with the recommended tire inflation pressure is essential, it directly
determines the performance of the vehicle and driving safety. Check tire wear and
pressure from time to time.
Six Hundred 650cc pressure: Front - 2,8 bar / Rear - 2.9bar