9
Temperature control (optional feature)
How to connect exchangeable AC-plugs
The following exchangeable AC plugs are available:
Type 018110 - ”EURO”
250V 2.5A (EN50075/IEC83 C5 II)
Type 018111 - ”US”
125V 2.5A
(NEMA 1-15 / CSA-C22.2 No.42)
Type 018112 - ”UK”
250V 13A (BS 1363)
Type 018114 - ”AUS”
250V 10A (AS/NZS 3112)
Mains Cord Set is available on request if you wish your product to be ”DeskTop”
lf the charger is used with a temperature sensor
(NTC-resistor in the battery) it is possible to add
control to the battery charging process. lf the
battery temperature is too low (< 0°C) at the start
of the charge cycle, the charger will charge with
trickle charge current until the temperature level
is safe. This is indicated by an intermittent orange
flash while the LED is green. The same will take
place if the battery temperature exceeds 40°C. The
current will then remain low until the temperature
is at a level where fast charge can start. lf the
temperature is too high for safe charging (> 60°C),
the LED will show ”error” by intermittently flashing
orange and green. By using the temperature
increase control (+dT/dt), the charger will switch to
top-off charge and later to trickle charge the same
way as charging with -dV control.
NOTE. The charger may be programmed for other temperature parameters. See a separate user manual or
contact supplier for additional information.
Zero dV feature (optional feature)
lf zero dV has been activated, the charger will stop the fast charge when the voltage has not increased
the last 5 minutes. This feature may be the only sensor, or it may be used in combination with -dV and/or
+dT/dt
