Marzocchi QR20 Plus, Руководство пользователя

Страница: 18 / 39

Installation
M
Z
010
English
3
86
3 INSTALLATION
3.1 Installing on the frame
The fork is supplied with “ A-Head Set ”
(threadless) steer tube to be cut according to
frame size it will be used on.
Installing the fork on the bicycle frame is a very
delicate operation that must be carried out by
specialized personnel.
ATTENTION
IThe assembling on the frame and the steer
tube adjustment must be carried out in
compliance with the manufacturer’s
instructions. Improper installation may
jeopardize the safety of the rider.
Marzocchi does not guarantee the
installation and refuses all responsibility for
damages and/or accidents that may be
caused by an incorrect installation.
The steer tube must be pressed into the crown;
its replacement must be carried out by one of
our service centers only, using the required
tools.
ATTENTION
In case of improper installation of the steer
tube into the crown, the rider might lose
control of his/her bicycle, thus jeopardizing
his/her safety.
ATTENTION
On the DropOff Triple model,, the lower
crown is clamped to the stanchions through
some bolts. During installing, you will have
to verify that, keeping the fork’s legs fully
compressed at bottom end, the distance
between the tire (inflated) and the lower part
of the lower crown must be bigger than 4
mm.
3.2 Fender installing
The Ø 32 mm legs forks can be equipped with an
integrated fender. The fender can be provided
with the fork or purchased separately.
When assembling the fender (
A ) you must insert
the small support bushing ( B ) between the screw
and the fender as shown in the picture, and
tighten the screws (
C ) with a 8 mm Allen wrench
to the required torque (see Table - Tightening
Torques).
8 mm
MZ
00
9054
A
B
C
3