Insert the pre-assembled valve in the piston rod from the three-point ring side as shown.
Insert the valve and the pumping element (
3
) into the stanchion.
Take great care not to damage the segment and if necessary use a small flat-tip screwdriver to help the piston of the pumping
element into the stanchion.
Using the special round-nose pliers, mount the stop ring (
2
) and check it fits perfectly into its groove.
Fit the bottom pad (
1
) to the pumping element rod.
Assembling: Assembling the ETA cartridge
Insert spring (
2
), the preload tube (
7
) and washer (
3
) in the ETA cartridge rod.
Screw down nut (
1
) without tightening.
During this operation, it might be necessary to slightly preload the spring pressing down
washer (3) so that it can counteract the action of the spring. Never direct the assembling side
of the fork towards people or animals.
© Marzocchi Suspension
2005
-
MX Comp ETA
