Super T
QR20
23
22
FIG. 17
Insert the stop ring
(23)
into the slider
making sure it is properly seated into place.
Use buffer
(B)
to properly seat the ring into
the slider.
FIG. 18
Lubricate the dust seal
(22)
and fit it into the
stanchion from the spring end.
FIG. 19
Fit the stanchion tube
(28)
gently into the oil
seal
(24)
, together with dust seals.
Rotate the stanchion tube while inserting it
into the seal to reduce the chance of dam-
aging the seals.
Turn the slider over and check that cartridge
thread
(21)
is sticking out through the slider
hole.
Check to see that the stanchion tube slides
unrestricted by cycling the fork up and
down several times.
The tube should slide freely inside the seal
assembly without any side play.
In the event it is too hard or too soft, repeat
the previous steps described above and
check components to ensure they are not
damaged.
Seat the dust seal
(22)
on top of the slider.
28
22
