2 of 6
v1.2
Opening the Chassis
1.
Turn-off and remove power from the chassis.
2.
Remove the bumpers from the back of the chassis using the Torx-10 screw driver. Note
Figure 2 below. Also note that the bumpers are keyed and their locations should be
noted and retained for reinstallation.
3.
Remove all screws from the two sides of the chassis using the Phillips screw driver.
Retain all removed hardware for reassembly. Note Figure 3 below.
4.
Lift and remove the top shell from the chassis. The bottom shell can be left on as the
power supplies can be accessed from top.
On the backplane of your chassis, you will find two 20 or 24-pin backplane power connectors.
One such connector is depicted in Figure 4, below.
Figure 4:
GX73xx Backplane Power Connector
Figure 2:
Chassis Bumpers
Figure 3:
Chassis Side Panel
