15
USING YOUR BEER DISPENSER
Mounting
bracket
Screws (4)
Remove foam plug
from hole port
!
CAUTION
If the CO
2
tank is placed on the floor it must be secured in
the upright position with a chain or other means to prevent
it from being tipped over.
Reseal hole
around tubing with
the foam plug
CO
2
tank
placed in the
bracket
Figure 36
Figure 37
Optional CO
2
tank external mounting bracket:
Many options are available for mounting the CO
2
tank out-
side of the beer dispenser to gain additional cold storage
space inside.
Secure the optional external mounting bracket on the
back of the beer dispenser (this is ideal for mobile
units) or mount within adjacent cabinetry (ideal for
undercounter built-in units:
Mount the (4) screws (#10-32 x
3
⁄
4
" flathead machine
screws) provided with the bracket in the rear of the appli-
ance, see Figure 36. Do not completely tighten. Place the
keyhole slots in the flanges of the bracket over the four
screws and tighten them to secure the bracket to the back
of the cabinet. The bracket can also be fastened to adja-
cent cabinetry using the provided #10 x
3
⁄
4
" wood screws.
Mark the hole locations where required using a pencil and
the slots in the mounting bracket. Drill appropriate pilot
holes (depending on the material you are mounting to) and
secure the bracket per the above instructions.
The foam insulation plugs provided in the portholes are
CRITICAL
to proper functioning of the unit and prevent-
ing frost build up that can cause damage to the unit and/or
refrigerator contents.
ALWAYS
reseal the CO2 line porthole
(Figure 44) with the provided insulation plugs once all lines
have been properly installed.
Consider the length of the red air line when choosing a
place for the CO
2
tank. The red air line supplied is 4 feet
(1.2 meters) long.
With the gauges mounted to the CO
2
tank place the tank in
the mounting bracket.
Remove the foam plug from the hole port as shown in Fig-
ure 36, and feed the red CO
2
line through the rear wall and
out the coil cover on the inside of the cabinet. Connect the
red CO
2
line to the keg coupler.
Reseal the hole in the back of the cabinet with the foam
plug. See Figure 37.
NOTE
The optional mounting bracket is designed to hold the 5#
CO
2
cylinder that comes with the beer dispenser. Larger
cylinders may be purchased from a third party and mounted
externally. Use the hole port on the rear of the cabinet to
run the CO
2
line to the keg.
NOTE