Marvel 6SWCE-BB-G, Инструкция по установке, Страница: 4 / 4

6. INSTALL THE DOOR TO THE UNIT. USE THE SUPPLIED PLASTIC WASHERS AS SHOWN IN THE FIGURE BELOW.
2. PEEL BACK DOOR GASKET TO EXPOSE THE SCREW HOLES.
3. SET THE WOOD FRAME FLUSH TO THE FRONT OF THE DOOR IN THE DESIRED LOCATION. CLAMP WOOD FRAME TO
THE TOP HINGE. REMOVE THE DOOR BY ANGLING THE DOOR OFF OF THE BOTTOM HINGE PIN.
1. IF THE DOOR IS ATTACHED TO THE UNIT, REMOVE IT BY UNSCREWING THE TOP ALLEN HEAD SET SCREW AT
THE DOOR IF NECESSARY.
4. INSERT THE WOOD SCREWS THROUGH THE BACK OF THE DOOR INTO THE PILOT HOLES IN THE WOOD FRAME AND
5. REINSTALL DOOR GASKET BY PRESSING INTO DOOR CHANNEL. MAKE CERTAIN THE CORNERS ARE INSERTED FULLY.
7. REALIGNING THE DOOR MAY BE NECESSARY. ANY FINAL DOOR ADJUSTMENTS CAN BE MADE USING A 1/8 INCH ALLEN
8. ATTACH THE DOOR LIGHT STRIKER PLATE AS SHOWN USING THE HEX OR PHILLIPS HEAD SCREWS PROVIDED. MAKE
TIGHTEN.
HEAD DRIVER TO ADJUST THE DOOR'S HINGES (SEE FIGURE BELOW).
CERTAIN THE LIGHT IS ABLE TO TURN ON AND OFF WHEN THE DOOR IS OPENED AND CLOSED.
9. ATTACH THE DOOR TO THE UNIT BY REVERSING STEP NUMBER 1 ABOVE.
BOTTOM HINGE CORNER
CAUTION
DOOR CAN BECOME
DISENGAGED IF WASHERS
ARE NOT INSTALLED
TOP HINGE CORNER
SHOULDER BUSHING
.75 OD X .443 ID
.75 OD X .257 ID
SHOULDER BUSHING
WASHER
3 NYLON
HARDWARE
COMPONENTS
AT BOTTOM
HINGE
HARDWARE
COMPONENTS
AT TOP HINGE
2 NYLON
NOT INSTALLED AS SHOWN
COMPONENTS ARE NOT
PROPERLY-IF ALL NYLON
DOOR MAY NOT SWING
.625 OD X .218 ID
WASHER
WASHER
CAUTION
CAUTION
DOOR CAN BECOME
DISENGAGED IF WASHERS
ARE NOT INSTALLED
CABINET HINGE
WOOD
FRAME
WOOD
FRAME
DOOR HINGE
DOOR HINGE
HINGE HARDWARE
INSTALLATION DETAILS.