INSTALLING YOUR OUTDOOR REFRIGERATED DRAWERS
Select Location
The proper location will ensure peak performance of your
appliance. Choose a location where the unit will be out of
direct sunlight and away from heat sources. Best perfor-
mance will be maintained when installed within the follow-
ing parameters:
Unit should be operated in a properly ventilated area with
ambient temperatures above 40 degrees and below 100
degrees Fahrenheit.
Cabinet Clearance
Ventilation is required from the bottom front section of the
unit. Keep this area open and clear of any obstructions.
Adjacent cabinets and countertop can be installed on top,
back and sides of the unit as long as the grille and door
access remain unobstructed. An opening of 24 inches is
required between cabinets and a depth of 24 inches.
Leveling Legs
Adjustable legs at the front corners of the unit should be
set so the unit is firmly positioned on the floor and the front
is raised just enough so that the door closes easily when
opened about halfway.
Turn leveling legs clockwise to raise unit, counterclockwise
to lower it.
“Anti-Tip” Device
A cabinet “anti-tip” device is mounted to the back of your
refrigerated drawers. If your installation is a built-in under-
counter application, you do not need to apply this feature.
If your installation is a free-standing application with no
countertop directly above the top of the unit, you must
apply this feature to prevent the unit from tipping forward
when the drawers are pulled out. The “anti-tip” device is
attached to the back of the cabinet. Please see installation
instructions supplied with the “anti-tip” device.
WARNING
Do not splash or spray water from a hose on the re-
•
frigerator! Doing so may cause an electrical shock,
which may result in severe injury or death.
This unit should not, under any circumstances, be
•
ungrounded.
Grounding Method
This product is factory equipped with a power supply cord
that has a three-pronged, grounded plug. It must be
plugged into a mating grounding type receptacle in ac-
cordance with the National Electrical Code and applicable
local codes and ordinances (see Figure 1). If the circuit
does not have a grounding type receptacle, it is the re-
sponsibility and obligation of the customer to exchange the
existing receptacle in accordance with the National Electri-
cal Code and applicable local codes and ordinances. The
third ground prong should not, under any circumstances,
be cut or removed. All U.L. listed refrigerated products are
equipped with this type of plug.
A ground fault circuit interrupter electrical receptacle is
to be used to supply electrical power to the refrigerator
for outdoor applications. Contact an electrician if you
need to install one to supply electrical power to your
outdoor refrigerator.
Electrical Connection
Check the serial nameplate for the correct power supply.
Use only the electrical power supply specified on the serial
nameplate.
DO NOT USE AN EXTENSION CORD.
2
Figure 1
Содержание 24" Refrigerated Drawers 6ORDE
Страница 11: ...NOTES 10 ...
