Maruyama MS0835W, Руководство пользователя

Страница: 6 / 48

1
1 1
2
3
3
3
2
2
5
Operating instructions
CAUTION
CAUTION
CAUTION
● When starting the engine, make sure to put water or chemicals into the chemical tank.
Without water or chemicals in the tank, the pump will break down. Never run the pump dry.
● It is confirmed that the ball cock has closed before it starts.
Perform priming.Push priming
pump installed in front of the
carburetor several times slowly,
and confirm that fuel fills the
priming pump and returns to the
tank through the clear return line.
Turn the handle of the pressure control valve until there is
sufficient pressure for work such as spraying weeds (fixed
position).
After confirming proper pump and spray operation in the
machine, move the throttle lever to high-speed position.
When opening ball cock, chemicals will be sprayed from
nozzle in a mist.
Push stop button to stop engine.
When setting the pressure control valve handle to
"INSECTICIDE", "HERBICIDE" with throttle fully open at the
"HIGH PRESSURE" position of pressure control valve handle,
engine revolutions increase as pressure decreases. When
using this machine at the "INSECTICIDE", "HERBICIDE"
position, use at a position little bit back from full open
throttle.
STARTING
When engine is started and when pump starts suction.
HERBICIDE
When engine is started and when pump starts suction.
When low-pressure spray is required. (Spray of weed
killer, etc.)
INSECTICIDE
Normal spraying work
HIGH PRESSURE
1.When high pressure is required in particular.
2.When this machine is set at a fixed position and longer
hose than standard is used.
Close ball cock.
Return throttle lever to low speed.
Engine will start.
After pulling starting rope gently by two or three times,
pull it hard to start the engine.
Return choke slowly.
If the engine does not start by repeated action, try
pulling the rope after fully opening the choke.
If the engine still does not start, refer to page 7.
[Pulling method for starting rope]
1.Grasp starting rope tight with right hand.
2.Hold chemical tank with left hand.
3.Pull starting rope slowly until resistance is felt.
4.Pull starting rope straight from entrance of starter.
5.Do not pull starting rope to the end.
6.Do not release the starter rope handle when rope
is extended. Allow the recoil to rewind the rope
gradually.
Set handle of pressure control valve
at "STARTING" position.
Fully close the choke. (In hot
weather or when engine is hot,
the choke should be partly open
or fully open.)
Move throttle lever to medium-
and low-speed position.
Close
STARTING
HERBICID
E
INSECTICIDE
HIGH
PRES
SURE
Throttle lever
Throttle lever
Stop button
Push
4
5
6
Operation Stop