Maruyama MCV31R, Руководство владельца/оператора

Страница: 28 / 138

— US-27 —
TO STOP THE ENGINE
1. Release the throttle trigger.
2. Turn off the stop switch to the stop position (“ ”).
NOTE: In the case that engine does not stop at “ ” position, pull the “CHOKE KNOB” to stop engine. Pay
attention to the chain that starts to turn by pulling “CHIKE KNOB” during engine runs. Please check your
chainsaw at authorized service dealer immediately.
HOT RESTART
To start the engine that is already warmed up (hot restart), or if the ambient temperature exceeds 20°C:
1. Turn on the ignition switch, which is located on the front part of the rear handle, to the Start position.
2. Push the primer pump until fuel enters into the primer pump (5 - 6 times).
Pushing the primer pump is not needed to restart warm engine with enough fuel in tank.
3. Pull the starter grip.
4. If the engine fails to start after three to four pulls, follow the instructions in the Cold Starting Procedure section
above.
If the engine fails to start after you follow the above procedures, contact an authorized MARUYAMA dealer.
NOTE: 1. Don’t pull the starter cord out completely.
2. Don’t release the starter cord from the fully extended position.