Assembly
Assembling Engine and Drive
Shaft Assembly
The drive shaft, clutch drum housing and gearcase a
r
e
assembled Attach the clutch drum housing to the
engine using the four M5 x 20 screws supplied with the
unit
Engine
/
MS x 20 Screw (4)
Shaft
/_
---
Clutch Drum Housing
Loop Handle Installation
The loop handle kit contains a package of four screws
and nuts, a rubber sleeve and the bottom clamp for the
loop handle.
Nut (4J-__
----@
�""' Rubber Sleeve
Bottom Clamp
1
Slip the rubber sleeve around the shaft approxi
mately 9 inches (22 8 cm) from the end of the stop
switch/throttle trigger assembly for an initial han
dle position.
2 Rotate the rubber sleeve so the split is to one side.
3
Place the loop handle and the bottom clamp over
the rubber sleeve.
4 Install the four screws and nuts Leave the screws
finger-tight
5.
Reposition the loop handle up or down the drive
shaft to the most comfortable position, but no
closer than 9 inches (22. 8 cm) f
r
om the end of the
stop switch
6.
Tighten the screws and nuts.
-12-
