＿
US-5
＿
CUTTING BLADE
A variety of metal cutting blades are available
to satisfy different cutting conditions. It is
especially important to use only the correct
blade(s) approved for brushcutter. Also, it is
especially important to install the blade for
LEFT- HAND rotation (as viewed from the
operator’s position), and to correctly position
all blade holding parts (see sketch).
BEFORE OPERATION
FUEL : MIXING GASOLINE AND OIL
The two stroke engines used in the brushcutter requires a mixture of GASOLINE and OIL for lubrication of
bearings and other moving parts. See the chart below.
NOTE
: Gasoline and oil must be premixed in a clean gasoline container. Never mix gasoline and oil in
-
doors or in the burushcutter fuel tank. Always use fresh gasoline.
WARNING !! - NEVER USE GASOHOL OR ALCOHOL BLENDED FUELS IN MARUYAMA ENGINES.
Before filling the brushcutter fuel tank, clean around the fuel tank cap so dirt and debris does not enter the
fuel tank. Always shake the fuel container before filling the fuel tank. Remove the fuel cap, then fill the fuel
tank to within about 10mm from the top of the tank. Avoid filling the fuel tank filler neck. Install the cap se
-
curely onto the fuel tank.
Fuel Mixture Chart
Gasoline
Two-stroke oil
50:1
25:1
ISO-L-EGC/ EGD ,JASO class FC/ FD,
or equivalent two-stroke oil
ISO-L-EGB , JASO class FB,
or equivalent two-stroke oil
1 liter
20 mL
40 mL
2 liters
40 mL
80 mL
5 liters
100 mL
200 mL
Stabilizer
Blade nut
Left hand
thread
Clamping Washer
Cutting Blade
Boss Adapter
Gearcase
Holding Tool
(3mm Hex Wrench)