MARUTI SUZUKI 800, Руководство по обслуживанию

Страница: 491 / 644

REASSEMBLY
1) Inspect component parts (Refer to INSPECTION) and replace
with new ones as necessary.
2) Before installing over-running clutch (2) to armature (1), apply
grease as shown in figure and then fasten stop ring (3) with
snap ring (4).
“A” : Grease 99000-25010
NOTE:
Use new snap ring on shaft for installation. Do not reuse
snap ring.
3) Apply grease to drive lever (2) and combine it with armature (1).
Then assemble them with drive housing (3).
“A” : Grease 99000-25010
4) Install yoke and brush holder (3), then set 4 brushes (1) with
their springs (2). Install insulator.
NOTE:
When installing brushes, make sure that brushes and
commutator have been degreased thoroughly.
Check to confirm that brush parts do not have unneces-
sary contacts with others.
5) Install rear housing applied with grease in its bush inside.
Grease 99000-25010
6) Replace magnetic switch (1) or its boot (2) with new one, if re-
quired, then apply grease to plunger (3).
“A” : Grease 99000-25010
CRANKING SYSTEM 6G-7