Martin Mania DC3, Руководство пользователя

Страница: 18 / 28

18 Mania DC3 user manual
3. Turn the fixture over and remove the thumb screw holding the fixture
cover in place.
4. Slide the fixture cover open and place the fixture on its side.
5. If you have previously installed an oil wheel, remove it by loosening the
two grub screws in the oil wheel hub by approx. one full turn, sliding the
oil wheel off its spindle and withdrawing it through the housing as
illustrated above. Only loosen the grub screws enough to unclamp the
oil wheel from its spindle (approx. one full turn).
6. Pass the new oil wheel carefully through the aperture in the housing
and slide it onto its spindle. Pass one hand through the bottom of the
fixture and hold the oil wheel to support it, if necessary.
7. Use the 2mm Allen key supplied with the Mania DC3 to tighten the two
grub screws in the oil wheel hub and clamp the oil wheel in place on its
spindle. Check that the oil wheel is firmly attached and rotates without
fouling any other components.
8. Replace all covers, before reapplying power.
2 mm 2 mm