Martin Mania DC2, Руководство пользователя

Страница: 15 / 24

Basic service 15
2 Remove the thumb screw holding the cover in place.
3 Slide the fixture cover open as far as possible (there is a physical stop
point that prevents access to the power supply section).
4 Vacuum or gently blow away dust and loose particles with compressed
air.
5 Remove stuck particles with an unscented tissue or cotton swab
moistened with glass cleaner or distilled water. Do not rub the surface: lift
the particles off with a soft repeated press.
6 Remove smoke, and other, residues with cotton swabs or unscented
tissues moistened with isopropyl alcohol. A commercial glass cleaner may
be used, but residues must be removed with distilled water. Clean with a
slow circular motion from center to edge. Dry with a clean, soft and lint-
free cloth or compressed air.
7 Close the fixture cover and tighten the thumb screw, taking care not to
trap any loose wires.
L A M P M A I N T E N A N C E
Warning Isolate electrically before re-lamping. The lamp shall be
changed if it becomes damaged or thermally deformed.
Thumb screw