Martin Magnum 2500Hz, Руководство пользователя

Страница: 8 / 28

8 Quick Start
Quick Start
You are no doubt eager to switch on the machine and try it out by making a lot
of haze. This section tells you how to do that. However, please also make the
time to read the safety and servicing instructions in the remainder of this
manual.
Setting up
Locate the machine in a suitably large area with nothing in front of the haze
output.
Fill the fluid tank with MARTIN-approved haze fluid (see page 18). The fluid
compartment is opened by pulling outwards on the cover (pull using a finger in
the round hole).
Connect a suitably rated power supply to the machine. The power requirements
are:
4.15A at 230V (EU) or 8A at 120V (US)
Connect the remote control to the REMOTE IN connector on the rear panel.
Turn on the power switch. The red Heat indicator on the remote and the rear of
the unit will light. After about 6-8 minutes the green Ready indicator on the
remote and the rear of the unit will light. The machine is then ready to produce
haze. To obtain maximum haze output, wait another couple of minutes for the
Heat indicator to go out.
Making haze
Once the machine has heated up, press the FOG button on the remote to start
the haze output. The green ON light will come on. Press the FOG button again
to turn off the haze.
You can set the haze density by turning the knob. If the knob is turned fully
anticlockwise, no haze will be produced.