Martin Engineering M3786-03/19
5
Martin
®
Modular Slider Cradle
Installing Slider
Bars and Rolls
1. Slide center roll assembly (A) onto cross supports. Position assembly
under center of belt.
2. Slide wing weldment (B) with bars onto cross supports until weldment
contacts center roll assembly. Install wing weldment on opposite side.
3. Center cradle under belt.
4. Tighten cap screw (C) on lock mechanism to lock cradle in place.
5. Make sure there is 1 in. of clearance between end of bar and idler.
6. Loosen nuts (D and E) and position the slider bars so that they are
supporting conveyor belt below chute wall and skirting.
7. Tighten all cap screws and nuts.
A. Center Roll Assembly
B. Wing Weldment (2 used)
C. Cap Screw
D. Washer and Nut (8 used)
E. Cap Screw, Washers, and Nut (8 used)
Installation
