16
Cyclo 04 DMX user manual
DMX
OPERATION
The Cyclo 04 DMX may be programmed and operated with any lighting
control device that is compatible with the USITT DMX standard. This section
describes how to operate the system with a controller.
See “DMX protocol” on page 20 for specific control values.
Connecting a DMX control device
Connect a data cable from the Cyclo 04 DMX to the control device’s data
output. If the control device does not have an RJ-45 socket then you may
need to purchase or wire an XLR-to-RJ45 converter. For wiring information
see “Creating a data link” on page 9.
S E T T I N G T H E F I X T U R E T O D M X
O P E R A T I O N
DMX operation is enabled by setting pin 10 on the DIP switch to OFF. The
DIP switch can be accessed by loosing the cover access screw (do not
remove it completely) and sliding open the access plate (as shown in the
following illustration.)
