Martin-Till UMO-WA1345, Руководство по установке

Страница: 12 / 19

Offset Configuration ( Wheel in rear hole)
1) Place the deflector (scraper)on the back of the assembled wheel unit (previously assembled in
step 6) as shown here and pass the flange bolt (BFS0156) through the wheel assembly and the
deflector using the rear hole in the frame unit and attach the flange nut (NFSL007) hand tighten
and locate the deflector (scraper) as shown and torque the flange bolt (BFS0156) to 116 ft - lbs
being careful not to allow the deflector to rotate during bolt tightening.
2) The wheel marked TW3813 - L4 (Or RTW1412.5 - L4 for the Razor wheel) is for use on the left side
of the frame (as viewed from behind the machine). Repeat for opposite side.
NOTE: When the deflector (scraper) is used the washer (WSN0064) is NOT used
11
FLANGE BOLT
(BFS0156
REAR HOLE
FLANGE NUT
((NFSL007) NOT
SHOWN)