Martin Professional Extube, Руководство пользователя

Страница: 13 / 48

Physical installation 13
mounting clamp to the central slot in the back of the Extube housing, slide
the clamp a few millimeters to one side and retighten the screw.
Note that you must install extra screws through the DIN rail into the
mounting surface to secure Extube fixtures in vertical installations (see
“Vertical mounting” on page 14).
Mounting
Important! Mount fixtures on the
DIN rail one at a time.
Do not lift a line of
interconnected
fixtures, as you may
damage connections
or clips.
To mount the Extube on
a surface using DIN rail:
1. Fasten the DIN rail
securely to the
mounting surface.
2. See Figure 2. The
Extube mounting
bracket has a
hooked profile on
one side. Hook this
profile over the top
of the DIN rail and
swing the bracket
down (see A). Use
a 2.5 mm Allen key
to tighten the
mounting clamp
screw (see B).
Adding fixtures to form a line
To add another fixture:
1. Hook the additional fixture over the DIN rail,
then slide it along the rail and into position so
that the connections in the ends of the
fixtures engage fully.
2. Fasten the fixtures to each other by pressing
the supplied locking clips into the slots
provided in the ends of fixtures. Locking clips
Figure 2: Mounting on DIN rail
A
B
Figure 3: Locking
clip